Symbol Spectrum24 AP-4100 Series Product Reference Manual page 65

3. Select AP Installation from the Main Menu:
4. Verify the AP parameters reflect the network environment. Change them
5. Press TAB to scroll to the item and press ENTER to select.
AP-4100 Series Access Point Product Reference Guide
Symbol Access Point
Show System Summary
Show Interface Statistics
Show Forwarding Counts
Show Mobile Units
Show Known APs
Show Ethernet Statistics
Show RF Statistics
Show Misc. Statistics
Show Event History
Enter Admin Mode
as needed.
Symbol Access Point
.Country Config-[CR] United States
Unit Name
IP Address
.Gateway IP Address 0.0.0.0
.Subnet Mask
.DNS IP Address
.Net_ID (ESS)
.Antenna Selection Full Diversity
.DHCP/BOOTP
OK-[CR] Save-[F1]
(Most parameters take effect only after being saved and AP is reset)
MAIN MENU
AP Installation
Special Functions
Set System Configuration
Set RF Configuration
Set Access Control List
Set Address Filtering
Set Type Filtering
Set SNMP Configuration
Set Event Logging Configuration
Access Point Installation
Symbol Access Point
157.235.95.174
255.255.0.0
0.0.0.0
101
Enabled
Save All APs-[F2]
Configuring the AP
.Additional Gateways
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
.Additional DNS
0.0.0.0
0.0.0.0
Cancel-[ESC]
57