Table of Contents
Advertisement
Monitoring Statistics
3. Press ESC to return to the previous menu.
148
Access Control
WLAP Mode
Model Number
Serial Number
Hardware Revision
AP Firmware Ver
RF Firmware Ver
HTML File Ver
Radio Type
Start Flashing All
LEDs
Reset AP
Specifies if the access control feature is set to
one of three Access Control modes: Disabled,
Allowed, or Disallowed.
•
When Disabled (default) is selected, no
filtering is performed.
•
When Allowed is selected, only MAC
addresses specified in the Access Control List
are allowed to associate with the AP .
•
When Disallowed is selected, only MAC
addresses not specified in the Disallowed
Addresses List (Address Filtering) are allowed
to associate with the AP .
Specifies if enabling the wireless AP operation
status. If enabled, the AP sets up automatically
for wireless operation. This feature is
by default.
Identifies the model number.
States the APs unique identifier.
Specifies the hardware version.
Specifies the firmware version.
Specifies the Radio firmware version.
Specifies the HTML file version.
The radio type used by the access point
(4111, 4121 etc.)
Begins a test routine to check the LED
functionality and allows the user to determine
the AP location.
Clears the APs statistics and restores the last
saved configuration.
AP-4100 Series Access Point Product Reference Guide
Disabled
Advertisement
Table of Contents
