Subscribe to Our Youtube Channel
Related Manuals for Symbol IEEE 802.11A/B
Summary of Contents for Symbol IEEE 802.11A/B
- Page 1 Symbol IEEE 802.11A/B Access Port (Model WSAP-5030-100-WW) Hardware Quick Reference Guide Draft March 2003 - 1 -Model 5030 Access Port Quick Reference Guide DRAFT V3...
-
Page 2: Table Of Contents
Attaching the Access Port to the Suspended Ceiling Mounting Bracket .......14 Available Options ...........................16 Customer Support ..........................17 North American Contacts......................17 International Contacts........................17 Symbol Developer Program Web Site ..................17 Legal Information ...........................19 Regulatory Information.......................19 Applying the Regulatory Country Stamp..................19 - 2 -Model 5030 Access Port Quick Reference Guide DRAFT V3... - Page 3 If the appropriate stamp(s)is not provided, please contact your supplier..19 To apply the country stamp:....................19 FCC RF Exposure Guidelines ..................20 Safety Information ........................20 Remote and Standalone Antenna Configurations..............20 Power Supply ..........................20 Radio Frequency Interference Requirements ................21 Radio Frequency Interference Requirements –...
-
Page 4: To The Installer
To the Installer This guide is intended for the technician responsible for installing Symbol Technologies IEEE 802.11a Access Port. It is assumed that the technician is familiar with Ethernet LAN-based networking, terms and concepts. The installing technician should also have a working knowledge of mechanical assembly as well as an understanding of local building codes. -
Page 5: Introduction
The above/below ceiling and wall mounting options allow the unit to attach to the specified surfaces using only the mounting hardware provided. The Access Port receives power and transfers data through the same (CAT-5) cable or through a Symbol approved power supply. -
Page 6: Radio Characteristics
Radio Characteristics The Access Port can be configured as an IEEE 802.11 a/b compliant device. As an IEEE 802.11a device it supports 6, 9, 12, 18, 24,36, 48 and 54 Mbps data rates, utilizing transmit-only diversity, in the 5.15 to 5.825 GHz range. As an IEEE 802.11b device it supports 1.0, 2.0, 5.5 and 11.0 Mbps data rates, utilizing transmit and receive diversity, in the 2.4 to 2.5 GHz ISM radio band. -
Page 7: Overview
The WSAP 5030 system has two RJ-45 connecters (10/100 Ethernet ports LAN and ACC) that connect to the Symbol Technologies Wireless LAN Switch host and a daisy chained device. - Page 8 ½ an inch or a suspended ceiling tile with an unsupported span greater than 26 inches. Symbol recommends that the Access Port be fitted with a customer supplied Safety Cable suitable for the specific installation. The safety cable should be steel at least .06 - .10 inches in diameter similar to cable used to support T-...
- Page 9 Mounting Hardware Wall, Desk Rubber feet (4) Apply to bottom of Access Port only on desk mounted installations Metal mounting bracket Below ceiling and wall bracket are the same. Bracket is packaged with Access Port and not with mounting kit hardware items.
- Page 10 installation Light Pipe Decal For use with above ceiling installation. Display of AP exploded view and ceiling mounting hardware identified by item number. Review Site survey and network analysis reports to determine the method for Access Port installation. - 10 -Model 5030 Access Port Quick Reference Guide DRAFT V3...
-
Page 11: Surface Mounting
(must be customer supplied). Attaching the Access Port to the Mounting Bracket Hold the Access Port up to the bracket with the LEDs facing the installer, the Symbol logo right side up and the wired Ethernet port connections towards the floor. -
Page 12: Plaster Wall Board Ceiling Mount
(must be customer supplied). Attaching the Access Port to the Mounting Bracket Hold the Access Port up to the bracket with the LEDs facing the floor, the Symbol logo and port connections away from the installer. -
Page 13: Above Suspended Ceiling Tile (Plenum) Mount
½ an inch or a suspended ceiling tile with an unsupported span greater than 26 inches. Symbol recommends that the Access Port be fitted with a customer supplied Safety Cable suitable for the specific installation. The safety cable should be steel at least .06 - .10 inches in diameter similar to cable used to support T-... -
Page 14: Below Suspended Ceiling (T-Bar) Mount
Below Suspended Ceiling (T-Bar) Mount Display AP Ethernet cable/power connection. Ceiling mount H/W, Ceiling tile, Ceiling mount light pipe, Ceiling mount badge Determine the suspended (below) ceiling mounting location of the Access Port. Loosely assemble the two clip halves by holding the clip halves facing each other clip side up (place the long channel section of one clip half on top of the other) so they form a “U”... - Page 15 Ethernet cable from the ACC port to the LAN port on the daisy chained device. The Access Port receives power from an Ethernet cable or from a Symbol approved power supply. It supports the following Symbol-branded Power-Over-Ethernet devices and power supply.
-
Page 16: Available Options
Available Options Contact a Symbol sales associate for available Access Port radio and antenna options. Radio or Antenna Option Part number Notes Internal .11a antenna WSM-5040-110-WW Requires a special removal/installation tool. Not supplied by Symbol Technologies. External RSMA .11a Dipole... -
Page 17: Customer Support
Customer Support Symbol Technologies provides its customers with prompt and accurate customer support. Use the Symbol Support Center as the primary contact for any technical problem, question or support issue involving Symbol products. If the Symbol Customer Support specialists cannot solve a problem, access to all technical disciplines within Symbol becomes available for further assistance and support. - Page 18 Obtain additional information by contacting Symbol at: • 1-800-722-6234, inside North America • +1-516-738-5200, in/outside North America • http://www.symbol.com/ - 18 -Model 5030 Access Port Quick Reference Guide DRAFT V3...
-
Page 19: Legal Information
Legal Information Regulatory Information All Symbol devices are designed to be compliant with rules and regulations in locations they are sold and will be labeled as required. Any changes or modifications to Symbol Technologies equipment, not expressly approved by Symbol Technologies, could void the user’s authority to operate the equipment. -
Page 20: Fcc Rf Exposure Guidelines
20 cm from all persons. Power Supply Use only a Symbol-approved power supply 50-24000-049 output rated 48Vdc and minimum 0 A. The power supply is certified to EN60950 with SELV outputs. Use of alternative power supply will invalidate any approval given to this device and may be dangerous. -
Page 21: Radio Frequency Interference Requirements
Radio Frequency Interference Requirements This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. -
Page 22: Radio Frequency Interference Requirements - Canada
Symbol Declaration of Conformity (DoC) for details at http://www2.symbol.com/doc/ Statement of Compliance Symbol Technologies, Inc., hereby, declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A Declaration of Conformity may be obtained from http://www2.symbol.com/doc/... -
Page 23: Other Countries
Other Countries Mexico - Restrict Frequency Range to: 2.450 - 2.4835 GHz. Israel - Restrict Frequency Range to: 2.418 – 2.457 GHz. Sri Lanka- Restrict Frequency Range to: 2.400 – 2.430 GHz. - 23 -Model 5030 Access Port Quick Reference Guide DRAFT V3... -
Page 24: Copyright
Copyright Copyright © 2003 by Symbol Technologies, Inc. All rights reserved. No part of this publication may be modified or adapted in any way, for any purposes without permission in writing from Symbol Technologies, Inc. (Symbol). The material in this manual is subject to change without notice. - Page 25 Telex: 6711519 http://www.symbol.com - 25 -Model 5030 Access Port Quick Reference Guide DRAFT V3...
Need help?
Do you have a question about the IEEE 802.11A/B and is the answer not in the manual?
Questions and answers