Symbol Spectrum24 AP-4100 Series Product Reference Manual page 84

Configuring the AP
The dot in front of certain parameters, functions or options (for example
Control
when choosing the
only among the same hardware platforms and same firmware versions.
2. Configure the settings as required:
76
) indicates these items update to all APs with the same Net_ID (ESS)
Save ALL APs-[F2]
DTIM Interval
BC/MC Q Max
Reassembly
timeout
Max Retries (d)
Max Retries (v)
option. Users can perform this option
Configure DTIM packet frequency as a multiple of
beacon packets. The DTIM Interval indicates how
many beacons equal one cycle. Users should not
modify this setting or risk damaging the
configuration.
Determines the memory allocated for the queue
used in the AP to temporarily hold broadcast/
multicast messages. Unit measure is in packets and
corresponds to maximum-sized Ethernet packets.
The default is .
10
Sets the time in
0.5
during a packet reassembly. Packet reassembly
occurs when a large RF packet is fragmented into
smaller wireless network packets. The default is
The maximum allowed retries before aborting a
single data packet transmission. The default is
Users should not modify this setting or risk
damaging the configuration.
The maximum allowed retries before aborting a
single voice packet transmission. The default is
Users should not modify this setting or risk
damaging the configuration.
AP-4100 Series Access Point Product Reference Guide
ms units before a time-out occurs
.Rate
.
9000
.
15
.
5