Performing Pings - Symbol Spectrum24 AP-4100 Series Product Reference Manual

Configuring the AP
17. Verify the accuracy of the version number on the System
18. Press CTRL+D to end the Telnet session.

2.15 Performing Pings

An access point sends a ping packet to an MU and waits for a response. Use
pings to evaluate signal strength between two stations. The other station can
exist on any AP interface.
This ping operates at the MAC level and not at the ICMP (Internet Control
Message Protocol) level.
No pings returned or fewer pings returned than sent can indicate a
communication problem between the AP and the other station.
136
The AP displays the Main Menu.
Symbol Access Point
Clear All Statistics
Clear MU Table
Clear ACL
Clear Address Filters
Clear Type Filters
Load ACL from File via TFTP
Load ACL from File via XMODEM
Load ACL from MU List
Reset AP
Configure Network Time
Summary screen.
Special Functions Menu
Restore Factory Config.
Save Configuration
Save Config. to All APs
Firmware Update Menu-[F3]
AP-4100 Series Access Point Product Reference Guide