Table of Contents
Advertisement
Configuring the AP
If using telnet to connect to the AP through an Ethernet interface, do not use
the
reset and look for the configuration file over the serial interface.
11. Under the function heading
12. Press ENTER.
13. The Firmware Update Menu displays
The Telnet session ends when the user answers Y at the prompt.
To view the file transfer log, switch to the TFTP application.
14. Telnet to the AP using its IP address.
15. At the prompt enter the password:
The password is case-sensitive.
16. Verify the network settings are correct on the System Summary screen.
17. Press CTRL+D to end Telnet session.
18. Repeat process for other APs in the network.
116
Use XMODEM to Update Access Point's Firmware
The WIRED LAN ACTIVITY indicator on the AP does NOT flash.
The AP resets when the file transfer completes.
Symbol
The AP displays the Main Menu.
option. This option causes the AP to
Use TFTP to Update Access Point's:
A
re You Sure? yes no
AP-4100 Series Access Point Product Reference Guide
select
.
Config
Type
.
Y
Advertisement
Table of Contents
