Table of Contents
Advertisement
Configuring the AP
2.17 Saving the Configuration
The AP keeps only saved configuration changes after a reset. To make
configuration changes permanent, save changes as needed.
To save all changes:
Press F1 in the configuration screens displaying the
the following procedure:
1. Select Special Functions from the Main Menu to display:
2. Select Save Configuration and press ENTER.
140
Symbol Access Point
Clear All Statistics
Clear MU Table
Clear ACL
Clear Address Filters
Clear Type Filters
Load ACL from File via TFTP
Load ACL from File via XMODEM
Load ACL from MU List
Reset AP
Configure Network Time
Next-[F3]
The
Save Config. to All APs
The function does not save other configuration parameters when
selected. Users can perform this option only among the same hardware
platforms and firmware versions. The NVRAM stores saved configuration
information. To clear the NVRAM-stored configuration, see section 2.19:
"Restoring the Factory Configuration" on page 141.
Special Functions Menu
Restore Factory Config.
Save Configuration
Save Config. to All APs
Exit-[ESC]
function saves the five preceding items.
AP-4100 Series Access Point Product Reference Guide
option or complete
Save
Advertisement
Table of Contents
