Table of Contents
Advertisement
Configuring the AP
To configure the AP for wireless operation:
1. Select Set RF Configuration from the Main Menu.
2. Configure the settings as required:
86
WLAP Mode
WLAP Priority
Specifies the APs wireless-AP operation status.
Enabled
•
the AP sets up automatically for wireless
operation. The AP can operate in any of
these configurations: Wireless, Repeater or
Ethernet Bridge.
Disabled
•
no wireless operation possible. Default
setting.
Link Required
At power up:
•
If the WLAP is the Root AP , an Ethernet
connection is required.
•
If the WLAP is a designated WLAP ,
association to the Root AP is required.
During normal operation:
•
If the Ethernet connection is lost, the Root
AP resets.
•
If the WLAP association is lost, the
designated WLAP resets.
Allows a user to determine the Root and the
designated WLAP in wireless operation.
Concatenate the priority value as the most
significant portion of the MAC address. An AP
with a lower numerical value for priority is more
likely to become the root AP . The default is
hex from the
0 - 0xFFFF
AP-4100 Series Access Point Product Reference Guide
8000
range.
Advertisement
Table of Contents
