Defining The Memory Configuration Packet - Avery Dennison ADTP1 Reference Manual

See the following graphic for a representation of the following adjustments: dispense position,
backfeed distance, supply position, print position, and margin position.
D e f i n i n g t h e M e m o r y C o n f i g u r a t i o n P a c k e t
Use the memory configuration packet (M) to customize the size of the printer's buffers.
Memory must be allocated in 1/2K increments. The memory configuration packet does not accept
decimals, so enter whole numbers. Multiply the amount to reallocate (in K) by 10. For example,
To reallocate (in K)
2.5
153
229.5
Each buffer's allocated memory remains in effect until that buffer is reallocated. For this reason,
reallocate all the buffers when reallocating any buffer. Reallocating more memory than what is
available causes an error.
Syntax
{I,M,buffer,device,buffer_size | }
M1. M
M2. buffer
M3. device
M4. buffer size
2-18 Packet Reference Manual
Enter this amount
25
1530
2295
Memory Configuration Packet
Buffer type. Options:
D Downloadable Fonts
F Format
I Image
Storage type. Use R for volatile RAM. Packets stored in volatile
RAM are deleted when the printer is turned off.
Buffer size in 1/10K ranges. The following table lists the
configured buffer sizes and min-max values for the printer. The
printer's configuration is stored in non-volatile RAM and saved
when the printer is turned off.
The maximum value for each buffer is listed; however, the sum of
all the buffers cannot exceed the maximum available memory of
the printer.