Avery Dennison ADTP1 Reference Manual page 31

Command Parameter
^PR
Resets the printer. This command takes five seconds to complete and then the
printer is ready to receive data. It has the same effect as turning off and then
turning on the printer.
Note: Command should be used only when the printer is not printing.
^RB Repeats the last printed batch, printing the same number of labels as
specified in the original batch. This command does not work if using batch
separators.
Note: Printer ignores this command if printing.
^RM Checks the RFID hardware version.
^RS
Resynchronizes supply when supply roll is changed.
Note: Printer ignores this command if printing.
^SD or Disables the status polling feature by turning off the status polling control
^SCd character. Sets the status polling control character to the ASCII value given by
the d parameter. The value of d can be any ASCII character.
^SFa Loads script with host response.
^SFb Loads script without host response.
^SFc
Enables script.
^SFd Disables script.
^SFe Uploads script version information.
^SFf Deletes script.
^SFg Turns on ENQ status polling before it reaches the script.
^SFh Turns off ENQ status polling before it reaches the script.
^SFi Turns on immediate commands before it reaches the script.
^SFj Turns off immediate commands before it reaches the script.
^TC Prints a series of three test labels: printer, MNet2, and MPCL.
^TP Prints a test label.
Note: Printer ignores this command if printing.
^VLC
Only clears the data that has been uploaded, not all the logged data. Data is
cleared with this command after a successful upload. Clear the log file after
uploading.
^VLD Disables bar code verifier data logging (default when the printer is reset).
^VLE Enables bar code verifier data logging.
^VLU Uploads the log file to the last port that received host data (serial, USB, or
Ethernet). Repeat this command until data is successfully uploaded. Data can
be cleared after it has been uploaded.
Configuring the Printer 2-15