Machine Faults - Avery Dennison ADTP1 Reference Manual

Error Description
Code
740 RFID Tag Failure. The RFID module detected a problem during encoding. This error
also occurs when TID singulation fails. Call Technical Support.
741 RFID inlay missing. Inlay not found in RF Field (area inside the printer where RFID inlay
is programmed.) This may be a bad RFID inlay.
♦ For continuous 741 messages:
♦ The inlay may be moving too fast to encode. Decrease the printer's speed and
try again.
♦ Make sure the correct values are set for the selected inlay and try again.
When using non-stop encode, adjust the start encode position by 10 and try
again. If using stop-to-encode, adjust the encode position by 10 and try again.
♦ Call Technical Support.
744 Inlay locked fail. The RFID inlay is unable to be programmed, because it is already
locked. This is considered a bad RFID inlay.
748 Verify mismatch. The external RFID verifier read the EPC data and it does not match the
programmed data so it failed RFID verification. If this message appears frequently,
adjust the tag verify position and try again. Make sure the printer has the external verify
option installed. This is a bad RFID inlay. The operator must not use this inlay. If tag
saver is set to yes, this inlay may have an overstrike pattern. If tag saver is set to no,
this inlay will not have an overstrike pattern
749 RFID verify fail. The RFID verifier could not read the inlay. Adjust the tag verify position
and try again. Make sure verification is enabled and the printer has the external verify
option installed. This may also be a bad RFID inlay.
Machine Faults (Continued)
Error Description
Code
750 Printhead is overheated. Turn off the printer to let the printhead cool. If the error
persists, call Technical Support.
751 Printer did not sense a black mark when expected. The supply may be jammed.
For errors 751-753, check the supply tracking, supply marks, black mark sensor position,
and supply roll for binding. Press ESCAPE and try to continue printing. If the error
continues to appear, change the supply
752 Printer sensed a mark in the wrong place.
753 Printer sensed a mark that is too long.
754 Printer has a ribbon problem. Check the ribbon for a jam or remove any slack by turning
the take-up reel clockwise. Load a new ribbon.
755 Printhead is open. Close the printhead before continuing. If the error persists, call
Technical Support.
756 The printer is out of supplies. Load supplies and/or clean the supply sensor.
757 Load supplies. The calibrated supply length differs by plus or minus .25 inches from the
format. Press ENTER to print on the current supply or load new supply and press
ESCAPE, then SELECT.
758 Check supply. Either the supply is not seen, or the on-demand sensor is broken
(purchase optional). Check for a label jam. Clear the supply path or reload supplies.
This error may occur when removing a label too quickly in on-demand mode. The printer
does not recalibrate after this error.
8-14 Packet Reference Manual