Avery Dennison ADTP1 Reference Manual page 24

B3. ribbon
B4. feed_mode
B5. supply_posn
B6. cut_posn
B7. skip_index
2-8 Packet Reference Manual
Ribbon. 1 is the default. Options:
0 Ribbon not installed
1 Ribbon installed
2 High Energy Ribbon
Use a print speed of 2.5 IPS with the high energy ribbon.
Serial bar codes cannot be printed with the high energy
ribbon.
Settings for ribbon and supply type must match the
supplies loaded in the printer; otherwise, an error occurs.
To clear the error, change the configuration packet and
resend it.
Feed Mode. 0 is the default. Options:
0 Continuous operation
1 On-demand mode
2 Liner take-up
Supply Position. Adjusts the position of the supply relative to the
index marks in the feed direction. Range: -300 to 300 in 1/203
inch. 0 is the default. Increase the supply position to move print
up, decrease to move print down on the label. This adjustment
accounts for mechanical tolerances from machine to machine.
The supply position adjustment only needs to be made on the
initial machine setup.
The supply position cannot be changed while the printer is
active. Changing the supply position effects the print position,
dispense position, and backfeed distance. Once the supply
position is set, use the print control packet and backfeed control
packet to adjust printing and the dispense position.
Cut position. Range: -300 to 300 in 1/203 inch. 0 is the default.
Adjusts where the tag is cut. The printer adjusts the cut position
according to the index marks on the supply. Aperture supplies
may need adjustments. Increase to move the cut up, decrease to
move the cut down.
Skip index mode. 0 is the default. Options:
0 Disable skip index mode
1 Enable skip index mode. Allows the printer to skip (ignore)
a sense mark and print an image over multiple labels.