Avery Dennison ADTP1 Reference Manual page 146

Error Description
Code
623 There are more than 10 bar codes on one label for the bar code verifier to scan.
Redesign the format or disable the bar code verifier.
700 Error pending and the printer cannot continue with batch.
701 Printer received a command that it cannot execute while it is running.
702 SETUP setting is invalid.
M a c h i n e F a u l t s
These errors occur when there is a problem with the printer.
Error Description
Code
703 The printer sensed a calibration of different-sized black marks. Make sure the correct
supply is loaded.
704 Printer has not sensed a supply mark within the specified number of inches or out of
supplies. Check the
♦ supply tracking
♦ black mark sensor position
Press ESCAPE. If the error continues to appear, change the supply and/or clean
the supply sensor.
706 The motor could not get up to speed within the allotted time.
707 The motor reached desired speed but could not maintain it.
708 The motor has stalled or is running too slow to measure the speed.
710 Band out of data.
711 UART receiving communication error (framing, parity, etc.).
712 Receiving failure or command overrun error.
713 Receiving failure or illegal command.
714 Receiving failure or undefined command.
730 A memory allocation error occurred during initialization.
8-12 Packet Reference Manual
♦ supply marks
♦ supply roll for binding.