Defining The Batch Control Field - Avery Dennison ADTP1 Reference Manual

D e f i n i n g t h e B a t c h C o n t r o l F i e l d
The batch header must precede this field. The batch control field defines the print job and applies
only to the batch that immediately follows.
The batch control field overrides the settings made at the printer. For example, the printer's
cut mode is set to disabled; however, the batch control field specifies to cut each tag, so each
tag in the batch is cut.
The batch control field also overrides settings made in the online configuration packets.
For example, the Supply Setup Packet is set for liner take-up mode; however, the batch control
field specifies continuous mode, so continuous mode is used for the batch.
Syntax
E,feed_mode,batch_sep,print_mult,multi_part,cut_mode,cut_mult,
ver_mode,cable_det,rotate_img |
E1. E
E2. feed_mode
E3. batch_sep
E4. print_mult
E5. multi_part
E6. cut_mode
6-4 Packet Reference Manual
Batch Control Field.
Feed Mode. 0 is the default. Options:
0 Continuous Feed
1 On-Demand
2 Liner take-up (optional)
Note: For peel mode, the minimum supply length is 1.50 inches.
Batch Separator (striped label in between batches). 0 is the
default. Options:
0 Does not print a separator
1 Prints a separator
2 Double-length separator – prints 2 tags
Note: Do not use batch separators with continuous (non-indexed)
supply. If using a stacker, the batch separator is always 3.66
inches long.
Number of tags (1 to 999) with the same image. 1 is the default.
Number of identical parts on one tag (1 to 5). 1 is the default.
Enables or disables the optional cutter. Since the cutter is 3.4
inches away from the printhead, printed tags may be left between
the printhead and cutter. 0 (does not cut) is the default.
Printed tags left between the printhead and cutter - Options:
1 Cuts each tag.
2 Cuts in strips, not each tag.
4 Does not cut before first tag, cuts each tag.
None or one printed tag left between the printhead and cutter -
Options:
3 Cuts each tag.
5 Cuts in strips, not each tag.