Communication Errors - Avery Dennison ADTP1 Reference Manual

Communication Errors

Error Description
Code
409 The printer memory is full. Delete unnecessary formats or graphics from memory. Use
run length encoding to map large graphics. To use flash memory, format it first. See
"Formatting Flash Memory" in Chapter 2 for more information.
410 Parity on the printer does not match the parity on the host. Check the parity setting
under SETUP options.
411 Framing error. The printer cannot communicate with the host. Make sure the host is
turned on, communication cables are connected correctly, port settings are correct, and
communications are active. Check the baud rate, word length, and stop bits to make
sure they match those at the host. Re-transmit the data.
412 There is a problem with flow control between the printer and the host. Make sure the
printer and the host flow control settings match (both are DTR or both are XON/XOFF).
If the error persists, call Technical Support.
413 Online receive buffer is full. Check the printer's XON/XOFF or DTR SETUP values to be
sure there is not a flow control problem.
414 The internal keyboard buffer is full or replace the keypad. Call Technical Support.
415 The defined buffer size exceeds the total available memory.
416 Flash/PC board error. Call Technical Support.
417 Flash memory is full. Clear flash. Resend the format, graphic, and check digit packets.
If the error reappears, call Technical Support.
420 Internal software error relating to uploading.
421 Internal software error relating to location name.
422 Internal software error relating to duplicate name.
423 Internal software error.
424 Item in use.
425 Item already checked out.
426 Item not checked out.
427 Format name is invalid. Valid name is 1 to 8 characters inside quotes or "" for a printer-
assigned name. Press ESCAPE and try to continue. If the error reappears, call
Technical Support.
428 Batch name is invalid or graphic not found. Press ESCAPE and try to continue. If the
error reappears, call Technical Support.
429 A field number appears more than once in a format.
430 The format uses a graphic packet that cannot be found.
431 Internal software failure. Format name in task does not match the task name added.
432 Internal software failure. Graphic name in task does not match the task name added.
433 The batch references a field number that does not exist in the format.
434 Internal software error caused by a downloaded task that is not executable. Turn off the
printer, wait ten seconds and turn it back on.
435 Internal software error caused by a downloaded task that already exists. Turn off the
printer, wait ten seconds and turn it back on.
497 An error occurred during the loop back test on the parallel port. Call Service.
499 An error occurred during the loop back test on the serial port. Call Service.
8-10 Packet Reference Manual