Recommended Cutter Operation - Avery Dennison ADTP1 Reference Manual

Description of cut mode operation:
Cut Mode Cut Before first tag
0
1
2
3
4
5
No* Cut Modes 3 and 5 minimize the number of tags left between the printhead and the cutter.
Depending on the length of supply being cut, there may be one tag left between the printhead and
the cutter.
Yes*
The last tag in the batch is queued to be cut once it reaches the cutter; however, there may be printed tags
left between the printhead and the cutter. The user must send another batch to feed the last tag out far
enough to be cut.
Note: Using "overstrike/continue" as the Error Action minimizes the number of RFID tags left
between the printhead and cutter. To use the least amount of RFID tags, set overstrike
to five.

Recommended Cutter Operation:

With
Printhead RFID
Density Supply
203 No
203 No
203 RFID is not supported with 203 dpi
203 RFID is not supported with 203 dpi
300* No
300* No
300* Yes
300* Yes
*
Contact Service to order replacement 300 dpi printheads (KST) for use with the cutter and RFID
supplies.
E7. cut_mult
E8. ver_mode
Cut Between
in Batch?
No
Yes
Yes
(Feeds strips)
Yes
No
Yes No (Feeds strips)
With
Stacker
Attached Recommended Cut Modes
No 1, 2, 4 – Note: Cut Modes 3 and 5 may cause ribbon tearing
Yes 1, 2, 4 – Note: Cut Modes 3 and 5 may cause ribbon tearing
No 1, 2, 3, 4, 5
Yes 1, 2, 3, 4, 5
No 1, 2, 4
Yes 3, 5 – Note: Some RFID supplies may curl and cause a jam (with cut
mode 3). If this happens, use cut mode 1.
Number of tags to print before cutting. A cut multiple of one cuts
after each tag. The range is 0 to 32,000. 0 is the default. The
cut multiple is a multiple of the print quantity. If the cut multiple
is three and the print quantity is 16, then five sets of three tags
and one set of one tag is produced.
Note: The last tag in the batch is always cut, regardless of the multiple.
Bar code verifier mode. Enables or disables the bar code verifier.
For more information about enabling the bar code verifier, refer
to the Verifier's Operating Instructions. 0 is the default. Options:
0 Disable verifier - not using a verifier
1 Enable verifier
Cut After
Tags? Batch?
No
Yes Yes*
No Yes*
Yes Yes**
Yes Yes*
Yes**
Printed tags left between
printhead and cutter?
No No
Yes*
Yes
No*
Yes
No*
Printing 6-5