Inner Plunging Joint / Boot Replacement - Polaris xp 2013 eps Service Manual

FINAL DRIVE
18. Install and tighten the large clamp using the
appropriate clamp tool.
Axle Boot Clamp Tool: PU-48951
CV Boot Clamp Pliers: 8700226
19. While pulling out on the CV shaft, fully extend the CV
joint and slide a straight O-ring pick or a small slotted
screw driver between the small end of the boot and
the shaft. This will allow the air pressure to equalize
in the CV boot in the position that the joint will spend
most of its life. Before you remove your instrument,
be sure the small end of the boot is in its correct
location on the shaft.
20. Install and tighten the small clamp on the boot using
the appropriate clamp tool.
Axle Boot Clamp Tool: PU-48951
CV Boot Clamp Pliers: 8700226
7.36
or
or
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.

Inner Plunging Joint / Boot Replacement

1. Use a side cutters to cut and discard the boot clamps.
2. Remove the large end of the boot from the plunging
joint and slide the boot down the shaft.
3. Clean the grease from the face of the joint and place
the drive shaft in a soft-jawed vise.
4. Using a soft-faced hammer, or brass drift, strike the
inner race of the joint to drive the joint off the shaft. Be
sure to tap evenly around the joint to avoid binding.
Actual boot clamp may
differ from what is shown
Brass Drift Shown