Passcode Policy - Fuji Xerox DocuCentre-IV C2260 Administrator's Manual

5 Tools
Smart Card Certificate Verification
Set whether or not to verify the smart cart certificate when a user uses the smart card.
When [Enabled] is selected, the owner of the smart card is verified not only by PIN code
verification but by certification verification of the smart card and private key match. In this
case, the upper level CA certificate of the smart card certification must be registered on the
machine.
When [Disabled] is selected, the owner of the smart card is verified by PIN code verification.
Delete Remote Accounts
Select whether or not to delete the user information saved in the machine for remote
authentication. Select from [Do Not Delete], [Weekly], and [Monthly].
For [Weekly], you can set the day and time. For [Monthly], set the date and time.
Note
Maximum Login Attempts by System Administrator
This feature protects the settings from being changed by someone impersonating your
system administrator. If authentication for a system administrator's ID fails more than
specified times continuously, access is denied.
You can specify a login attempt count from 1 to 10.
Note

Passcode Policy

5
Passcode Entry from Control Panel
You can set whether a passcode is required when the system administrator or a user uses
the machine. Selecting [On] enables [System Administrator's Passcode] setting and
[Passcode] setting for [Create/View User Accounts].
Selecting [Off] does not require the passcode, even if a passcode is set in the above settings.
Important • The setting of [Passcode Entry from Control Panel] is used for authentication on the
Note
Minimum Passcode Length
Set this item when you specify the minimum number of digits allowed for a passcode.
Set a value from 4 to 12 in 1 digit increments.
Note
Charge/Private Print Settings
You can set how received print jobs should be handled.
You can directly print jobs and temporarily store print jobs to Charge Print or Private Charge
Print for stored files.
The Charge Print feature prints the print jobs of authenticated users. But, using this feature,
you can also temporarily store print jobs and print them later by operating the machine. If
[Save as Charge Print Job] is selected, print jobs received are saved by a user ID for storage
set in a print driver.
The Private Charge Print feature stores jobs to the machine, using the login User ID or Sub
User ID at print instruction. You can print the jobs later by operating the machine. Only the
files of the login user and sub users linked are displayed on the touch screen, therefore, it can
help ensure privacy protection as well as prevent output from being left in the tray.
Note
250
• This setting applies only to a user who is authenticated by smart cards.
• The failure count is reset when the machine is restarted.
• To cancel the access rejection state, restart the machine by switching off and on the power.
machine. A passcode must always be entered when accessing from remote devices using
CentreWare Internet Services or the like, regardless of the use of passcode setting.
Depending on authentication procedures, a passcode may be required for other processes
as well.
• The system administrator's passcode is also required when you change settings from
CentreWare Internet Services.
• This is only applicable to login users (not applicable to the system administrator and guests).
• Registered users can be authenticated with a passcode less than the minimum number of
digits.
• For more information on the sub user, refer to "Sub User" (P.342).