Fuji Xerox DocuCentre-IV C2260 Administrator's Manual page 422

14 Problem Solving
Error Code
C P F S M O
003-753
003-754
003-755
003-756
003-757
003-760
003-761
O O
003-763
003-780
003-795 O
005-210
14
005-275
005-280
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
420
Category
O [Cause]
[Remedy] Set [Resolution] to [200dpi], and scan the document again.
O [Cause]
[Remedy] Execute the job again.
O [Cause]
[Remedy] Check whether the document is blank or whether the side
O [Cause]
[Remedy] Set [Resolution] to [300dpi] or lower, and scan the
O O [Cause]
[Remedy] Confirm the selected options.
[Cause]
[Remedy] Change the paper size for the tray, or change the [Paper
O [Cause]
[Remedy] Place the Calibration Chart correctly on the document
Refer to "Executing Calibration" (P.86).
O [Cause]
[Remedy] Reduce the resolution or the ratio for [Reduce/Enlarge] to
[Cause]
[Remedy] Take one of the following measures:
O [Cause]
[Remedy] Switch off the machine power, make sure that the touch
O [Cause]
[Remedy] Switch off the machine power, make sure that the touch
Cause and Remedy
A mix sized document was to be scanned at high
resolution, 2 sided.
An error occurred in the document feeder.
The faxed document is completely blank.
of the document to be faxed is loaded correctly.
A mix sized document was to be scanned at high
resolution, 2 sided.
document again.
An incompatible combination of feature is specified for
document scan conditions.
The paper size of the tray selected for auto tray differs
from the paper size of the tray selected for Auto Paper
selection.
Type Priority] settings.
An error occurred when reading the Calibration Chart.
glass.
Failed to compress the scanned document.
decrease the data size, or split the data to send it
separately.
When enlarging/reducing a scanned document to the
paper size specified, the reduction/enlargement ratio
exceeds the allowed range.
Manually enter a reduction/enlargement ratio.
Change the paper size.
An error occurred in the document feeder.
screen is blank, and then switch on the machine power. If
the error still is not resolved, contact our Customer
Support Center.
An error occurred in the document feeder.
screen is blank, and then switch on the machine power. If
the error still is not resolved, contact our Customer
Support Center.