Fuji Xerox DocuCentre-IV C2260 Administrator's Manual page 465

Category
Error Code
C P F S M O
026-728
026-729
026-730
O O
027-400
027-442
027-443
027-444
027-445
027-446
027-447
027-452
027-500
027-501
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
O [Cause] An error occurred during WSD communications.
[Remedy] Check whether the network cable is correctly connected or
check the amount of available memory of the destination
device.
O [Cause] The size of paper loaded in the specified tray is unknown.
[Remedy] Check whether the paper guides are correctly positioned
in the tray, and then try again.
O O [Cause] Communications with the machine failed.
[Remedy] If other messages are displayed, confirm their content. If
the control panel is being operated, terminate the
operation. If remote access is being executed, wait until it
completes. If the error still is not resolved, switch off the
machine power, make sure that the touch screen is blank,
and then switch on the machine power.
If the problem persists, contact our Customer Support
Center.
O O [Cause] The IP address of IPv6 already exists.
[Remedy] Change the [Auto Stateless Address 1] for IPv6 on the
machine, or the IP address of IPv6 on the network device,
to remove the duplication of addresses.
O O [Cause] The IP address of IPv6 already exists.
[Remedy] Change the [Auto Stateless Address 2] for IPv6 on the
machine, or the IP address of IPv6 on the network device,
to remove the duplication of addresses.
O O [Cause] The IP address of IPv6 already exists.
[Remedy] Change the [Auto Stateless Address 3] for IPv6 on the
machine, or the IP address of IPv6 on the network device,
to remove the duplication of addresses.
O O [Cause] IP address for IPv6 set manually is incorrect.
[Remedy] Set the IP address correctly.
O O [Cause] The IP address of IPv6 set manually already exists.
[Remedy] Change the [Manually Configured IPv6 Address] on the
machine, or the IP address of IPv6 on the network device,
to remove the duplication of addresses.
O O [Cause] The IP address of IPv6 already exists.
[Remedy] Change the [Link-local Address] for IPv6 on the machine,
or the IP address of IPv6 on the network device, to remove
the duplication of addresses.
O O [Cause] IP address already exists.
[Remedy] Change the IP address set on the machine.
O O [Cause] Unable to connect to the SMTP server.
[Remedy] Specify the SMTP server name correctly or specify the
server by using its IP address.
O O [Cause] An POP server error occurred.
[Remedy] Execute the operation again. If the error still is not
resolved, contact our Customer Support Center.
Cause and Remedy
Error Code
14
463