Fuji Xerox DocuCentre-IV C2260 Administrator's Manual page 569

Output Destination
When you change the finisher to install, reconfigure the output destination under
[Tools] > [Copy Service Settings] > [Copy Defaults] > [Output Destination].
You can also change the output destination for Print E-mail, Private Folder Printed
Files, and Fax Received as required.
Restrictions on Method of Recipient Specification
The [New Recipients] and [Redial List] buttons may not be displayed when you
specify a recipient for fax/Internet fax/e-mail transmission if the method of recipient
specification is restricted in the System Administration mode. In this case, you
cannot use the numeric keypad either. Consequently, the recipients you can specify
are limited to those who are registered on the Address Book.
You must add an address book entry using CentreWare Internet Services or
ApeosWare EasyAdmin. The system administrator, however, can register new
recipients from the control panel of the machine even when the method of recipient
specification is limited.
The users who belong to an authorization group for which [Restrict Recipient
Selection Method] is set to [No Restriction] can directly specify a recipient for fax/
Internet fax or an e-mail transmission.
One Touch Buttons
The one touch buttons (only for fax models) are used to specify an address when
sending faxes or internet faxes. The buttons cannot be used when you specify an e-
mail address, a shared folder of SMB/FTP, or a server address.
The following two methods are available to assign the address numbers to the one
touch buttons.
[Type 1]: Assigns the one touch buttons 1 to 52 to the address numbers 0001 to
0052, and buttons 53 and 54 to the stored programming jobs 1 and 2.
[Type 2]: Assigns the one touch buttons 1 to 45 to the address numbers 0001 to
0045, and buttons 46 to 54 to the stored programming jobs 1 to 9.
Note • [Type 1] is selected by factory default.
For more information on how to change the number of address numbers assigned, refer to "One-touch
Buttons" (P.136).
Assigning to the One Touch Buttons
You can change the way how address numbers and stored programs are assigned to
the one touch buttons. When you have changed the assignment, some one touch
buttons that were used for address numbers before may be used for stored programs
while other one touch buttons that were used for stored programs before may be used
for address numbers. Be sure that you perform the correct operation.
USB Memory Slot on the Control Panel
To use the USB memory slot on the control panel, the USB Cable Kit (optional) is
required.
Insert a USB memory device directly into the USB memory slot on the control panel.
If you connect a USB memory device via a USB cable, the operation is not
guaranteed.
To connect a USB memory device via a USB cable, use the USB 2.0 interface
connector on the rear of the left side of the machine.
Notes and Restrictions
567
15