Fuji Xerox DocuCentre-IV C2260 Administrator's Manual page 530

15 Appendix
Setting Item
Reduce/enlarge
2 Up mode
Output
destination
Tray 5
confirmation
15
Grid lines
528
Item
Number
54 Sets the print magnification.
(Reduce/ [0] (Default)
enlarge mode) [1]
[2]
[Preset %] is a magnification automatically calculated based on [Original
Size] and [Paper Size], and reduces/enlarges the printable area of the
document to fit in the printable area of the output paper. Therefore, if the
size of the document and of the output paper are identical, the ratio will
be 100%. Also, if [2 Up] is selected, the document will be reduced to the
size at which two pages fit onto one sheet of paper.
[Variable %] is a magnification set in [Variable %] under [Reduce/
Enlarge]. A reference point for scaling (reducing/enlarging) is the upper
left corner of the printable area. This reference point applies to all text,
images, and graphics.
[Fit to Cut Sheet] prints the entire cut sheet area onto the printable area
of the output paper. It is a magnification automatically calculated based
on [Original Size] and [Paper Size], and reduces/enlarges the entire
document (including the area outside of the printable area) to fit onto the
printable area of the output paper.
17 Sets the magnification for the vertical or horizontal direction.
(Variable %/ [45 to 210] (Default:100): 45-210%
vertical
Note •When a continuous form paper is selected for [Original Size], print
magnification)
18
(Variable %/
horizontal
magnification)
21 Sets whether to print with the 2 Up or page by page. 2 Up is a feature
that prints two pages onto one sheet of paper. Depending on the paper
orientation, the two pages are printed side by side, or one above the
other.
[0] (Default)
[1]
[2]
Important •When [Landscape] is selected for [Original Size], print result is
9 Sets the output tray for the printouts.
[0] (Default)
[2]
[80]
67 Prints from Tray 5, after you instruct to print and then operate the
machine to start printing.
[0] (Default)
[1]
22 Sets the method for printing double-byte grid lines. The options are as
follows.
[0] (Default)
[1]
Value
: Preset %
: Variable %
: Fit to Cut Sheet
result is identical for [Preset %] and [Fit to Cut Sheet].
: Off
: Forward
: Reverse
identical for [Forward] and [Reverse].
: Center Tray or Center Tray - Lower
: Center Tray - Upper
: Right Middle Tray (optional)
: Off
: On
: Image
: Font