Replacing Staple Cartridge (For Finisher-B1) - Fuji Xerox DocuCentre-IV C2260 Administrator's Manual

3 Maintenance
4
Pinch both sides of the empty staple case
with your fingers (1), and remove the staple
case from the cartridge (2).
5
Insert the front side of the new staple case
into the staple cartridge (1), and then push
the rear side into the cartridge (2).
3
6
Push the staple cartridge into the finisher
until it clicks into place.
7
Close the finisher front cover.
Note

Replacing Staple Cartridge (for Finisher-B1)

When the optional Finisher-B1 is installed and the staple cartridge needs to be
replaced, a message appears on the touch screen. When this message appears, load
a new staple case into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and
Note
1
Make sure that the machine is not operating,
and open the finisher front cover.
66
• If the front cover is not completely closed, a message will appear and the machine will
remain paused.
performance. Use only staple cartridges recommended by Fuji Xerox.
• To order a staple cartridge, contact our Customer Support Center.