Fuji Xerox DocuCentre-IV C2260 Administrator's Manual page 556

15 Appendix
Parameter
Stapling
Manual feed tray
15
check indicator
Punching
Number of holes
554
Item No.
159 (Scaling) Sets whether the original size is enlarged or reduced so that the
document size fits the paper size.
[0]
[1] (Default)
160 (Scaling Selects the document size for auto scaling: A series paper (A0, A1, A2,
mode) A3, A4, and A6) or the active coordinate area which is determined
accordance with the setting selected in [Area Determination Mode].
[0] (Default)
[1]
Note • [Active Coordinate Area] can be selected only when [Auto layout] is
• The setting of the scaling mode is valid when [Document size] is set
161 (Active Sets the method to obtain the active coordinate area when auto scaling is
area being used.
determination [0] (Default)
command) [1]
[2]
[3]
[4]
Note • The setting of the active area determination command is valid when
162 (Paper Sets the paper margin when auto scaling is being used.
margin) [0] - [99] (Default: 0)
Note • The setting of the paper margin is valid when [Document size] is set
163 (Image Sets whether to perform image enhancement, which artificially increases
enhancement the resolution of an image and smooth its edges.
) [0]
[1] (Default)
164 Sets the stapling position.
[0] (Default)
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
[9]
165 [0]
[1] (Default)
166 Select the position for punching holes.
[0]
[1] (Default)
[2]
[3]
[4]
167 Select the number of punch holes.
[0] (Default)
[1]
[2]
Value
: OFF
: ON
: Paper Size
: Active Coordinate Area
set to [ON]. When [OFF] is selected, [Scaling mode] becomes [Paper
Size].
to [Auto].
: Auto
: PS
: IW
: IP
: Adapted
[Document size] is set to [Auto].
: 0 to 99 mm
to [Auto].
: OFF
: ON
: None
: Top Left
: Top Double
: Top Right
: Left Double
: Right Double
: Bottom Left
: Bottom Double
: Bottom Right
: Center
: None
: Yes
: None
: Top
: Bottom
: Left
: Right
: 2 holes
: 3 holes
: 4 holes