Fuji Xerox DocuCentre-IV C2260 Administrator's Manual page 480

14 Problem Solving
Error Code
C P F S M O
033-530
033-531
033-532
033-533
033-534
033-535
033-536
033-537
033-538
033-539
033-540
033-541
033-542
033-543
033-544
033-545
033-546
033-547
14
033-548
033-549
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
478
Category
O [Cause]
[Remedy] Confirm the procedure for DTMF in the User Guide, and
O [Cause]
[Remedy] Confirm the condition of the other machine (memory is full,
O [Cause]
[Remedy] Execute the operation again. If receiving, ask the sender
O [Cause]
[Remedy] Do not specify multiple sets.
O [Cause]
[Remedy] Confirm information such as the recipient and folder
O [Cause]
[Remedy] Execute the operation again.
O [Cause]
[Remedy] Execute the operation again. If the error still is not
O [Cause]
[Remedy] Specify the recipient correctly.
O [Cause]
[Remedy] Specify a connected line.
O [Cause]
[Remedy] Enter a correct fax number, and execute the operation
O [Cause]
[Remedy] Wait for a while, and then execute the operation again.
O [Cause]
[Remedy] Check whether the other machine is a facsimile.
O [Cause]
[Remedy] Check whether the line is connected correctly.
O [Cause]
[Remedy] No measure is required.
O [Cause]
[Remedy] Establish communication such as by telephone, and
O [Cause]
[Remedy] Wait for a while, and execute the operation again.
Cause and Remedy
Received a procedure disabled signal.
then execute the operation again.
Received a command rejection signal.
paper has run out, or other conditions), and execute the
operation again.
An error occurred during fax transmission.
to send again.
The other machine does not offer a feature to print the
number of document sets sent.
An error occurred during fax transmission.
information, and execute the operation again.
An error occurred during fax transmission.
An error occurred during fax transmission.
resolved, contact our Customer Support Center.
The recipient is not specified.
A line was specified that is not connected.
The recipient (fax number) is incorrect.
again.
The recipient's line is busy.
The other machine may not be a facsimile.
A dial tone was not detected.
Communication was terminated by a cause such as
pressing the <Stop> button.
Cannot transmit manually because a line is unavailable.
execute the operation again.
Cannot use the Fax service because of causes such as
memory is insufficient.