Fuji Xerox DocuCentre-IV C2260 Administrator's Manual page 439

Category
Error Code
C P F S M O
016-728
O
016-729
O
016-731
O
016-732
O
016-733
016-735
016-738
O
016-739
O
016-740
O
016-741
016-742
016-743
016-744
016-745
016-746
O
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
[Cause] An unsupported tag is included in the TIFF file.
[Remedy] Confirm the print data.
[Cause] Unable to print because the number of colors or the
resolution of the TIFF file exceeds the allowed range.
[Remedy] Change the number of colors or resolution for the TIFF file,
and execute the operation again.
[Cause] Unable to print TIFF data because it was interrupted.
[Remedy] Retry printing.
[Cause] The form specified by emulation has not been registered
at the host side.
[Remedy] Resend the form data.
O O [Cause] Probable causes are as follows:
1) Unable to obtain the IP address (the string after "@" in
the destination e-mail address) when e-mail is sent.
2) DNS server was unable to resolve the Internet address
(the string after "@") by the DNS server when e-mail is
sent.
[Remedy] For 1), confirm the e-mail address.
For 2), confirm the DNS server address.
O O [Cause] Attempted to print [Job Template List] while updating the
job template.
[Remedy] Retry printing after waiting for a while.
[Cause] Unsupported paper size was specified when specifying
booklet creation with PostScript (optional).
[Remedy] Specify a paper size supported for booklet creation, and
try printing again.
[Cause] Used an unsupported combination of document size and
paper size when specifying booklet creation with
PostScript (optional).
[Remedy] Specify a combination of document size and paper size
supported for booklet creation, and try printing again.
[Cause] Used an unsupported paper tray when specifying booklet
creation with PostScript (optional).
[Remedy] Specify a paper tray supported for booklet creation, and try
printing again.
O [Cause] An error occurred during the update process of the
machine.
[Remedy] Switch off the machine power, make sure that the touch
screen is blank, and then switch on the machine power. If
the error still is not resolved, contact our Customer
Support Center.
[Cause] An unsupported feature is included in the received PDF.
[Remedy] Print using a print driver.
Cause and Remedy
Error Code
14
437