Maximum Login Attempts; Passcode Policy - Fuji Xerox ApeosPort-III C2201 Administrator's Manual

5 Tools
Failed Access Log
In order to detect unauthorized access, an error is logged if authentication fails within a
specified period of time. Set the failure count.
Display Login Status
Set whether to display login status of a user on the upper-right corner of the login screen.
Logout Confirmation Screen
Set whether to display a logout confirmation screen every time a user session is to be ended.
User ID for Login
Set whether or not to make the user ID entry field on the user login screen case-sensitive.
Select [Case Sensitive] or [Non-Case Sensitive].
Important • Once this setting is changed, all the information about users, and the mailboxes and job flow
Save Remote Accounts in this Machine
Set whether or not to store user information used for authentication into the machine in the
Network Authentication mode.
5
Guest Passcode
Set the guest passcode to be used in the Network Authentication mode.
Delete Remote Accounts
Set the deletion timing of user information that is stored in the machine in the Network
Authentication mode. Select [Do Not Delete], [Weekly], or [Monthly].
For [Weekly], set the day of the week and time (hour and minute). For [Monthly], set the date
of the month and time (hour and minute).

Maximum Login Attempts

This feature protects the settings from being changed by an outsider pretending a
system administrator. If authentication for a system administrator's ID fails more than
specified times continuously, access is denied.
You can specify a login attempt count in the range from 1 to 10.
Note

Passcode Policy

Passcode Entry from Control Panel
You can set whether a passcode is required when the system administrator or a user uses
the machine. Select [On] to enable "System Administrator's Passcode" (P.236), and
"Passcode" (P.230) for [Create/View User Accounts].
Select [Off] not to require the passcode, even if a passcode is set in the above settings.
Important • The setting of [Passcode Entry from Control Panel] is used for authentication on the
Note
240
sheets linked to the users are deleted.
• When [Non-Case Sensitive] is selected, user IDs shown on screens and in reports become
uppercase.
• The failure count is reset when the machine is restarted.
• To cancel the access rejection state, restart the machine by turning off and on the power.
machine. A passcode must always be entered when accessing from remote devices using
CentreWare Internet Services or the like, regardless of the use of passcode setting.
Depending on authentication procedures, a passcode may be required for other processes
as well.
• The system administrator's passcode is also required when you change settings from
CentreWare Internet Services.