Fuji Xerox DocuCentre-IV C2260 Administrator's Manual page 554

15 Appendix
Extended Settings
Parameter
Auto layout
Active palette
No. of prints
Output
destination
2 sided printing
Alphanumeric
fonts
Position
adjustment
Number of sets
15
552
Item No.
106 Selects whether to perform auto layout of the document or not.
[0] (Default)
[1]
107 Selects whether to use a pen specified by command or set on the panel.
[0] (Default)
[1]
108 Sets the number of copy to be printed.
[1] 250] (Default: 1)
- [
109 Sets the output tray for the printouts.
[68]
[69]
[80]
[81]
110 Sets 2 sided printing.
[0] (Default)
[1]
[2]
112 Sets the font for single-byte characters.
For more information on fonts, refer to "Internal Fonts" (P.518).
[0] (Default)
[1]
[2]
113 Adjusts the hard clip area vertically or horizontally. You can set from -250
(Vertical mm to +250 mm in 1 mm increments.
position [0] (Default)
adjustment) [1] - [250]
[251] - [500]
114
(Horizontal
Important • Data outside the printable area is not printed regardless of the
position
adjustment of the print position. In addition, data moved outside the
adjustment)
printable area as a result of adjusting the print position is not printed.
115 Sets the method for specifying the print sets.
[0] (Default)
[1]
[2]
Value
: ON
: OFF
: Command
: Panel
: 1 - 250
: Stacker Tray (optional)
: Stacker - Top Tray (optional)
: Finisher Tray (optional)
: Right Top Tray (optional)
: None
: Head to head
: Head to toe
: Stroke
: Roman
: Sans serif
: Does not move the hard clip area.
: -250 to -1 mm
: +1 to +250 mm
: Protocol
: Panel
: Command