Fuji Xerox DocuCentre-IV C2260 Administrator's Manual page 476

14 Problem Solving
Error Code
C P F S M O
027-762
027-771
027-772
027-773
027-774
027-775
027-776
14
027-777
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
474
Category
O [Cause]
[Remedy] Execute the print job again. If the error still is not resolved,
O [Cause]
[Remedy] Delete unnecessary data from the server.
O [Cause]
[Remedy] Use ASCII characters to modify the host name that has
O [Cause]
[Remedy] Wait for a while, and then execute the operation again.
O [Cause]
[Remedy] Specify the e-mail address using only ASCII characters.
O [Cause]
[Remedy] Reduce the number of destination addresses. If the error
O [Cause]
[Remedy] Use ASCII characters to modify the host name that has
O [Cause]
[Remedy] Set [E-mail Send Authentication] to [Off] under [Tools] >
Cause and Remedy
An on-demand print job is sent to the machine using the
Web Applications feature, however, the specified job ticket
is invalid because of one of the following causes:
Abnormal change to the job ticket because of the
machine software failure
Abnormal change to the job ticket because of a bug on
the sender's remote server
Abnormal change to the job ticket because of network
trouble
Intentional alteration to the job ticket
contact our Customer Support Center.
The hard disk of the server connected to the machine is
full.
An error occurred during communication with the SMTP
server.
been specified under [Tools] > [Connectivity & Network
Setup] > [Machine's E-mail Address/Host Name]. If the
error still is not resolved, confirm with your network
administrator whether the SMTP server supports the
HELO command.
An error occurred during communication with the SMTP
server.
The specified e-mail address contains unsupported
characters.
Too many destination addresses have been specified.
still is not resolved, confirm with your network
administrator whether the SMTP server supports the
EHLO command.
An error occurred during communication with the SMTP
server.
been specified under [Tools] > [Connectivity & Network
Setup] > [Machine's E-mail Address/Host Name]. If the
error still is not resolved, confirm with your network
administrator whether the SMTP server supports the
EHLO command.
The destination SMTP server does not support SMTP-
AUTH.
[Connectivity & Network Setup] > [Outgoing/Incoming E-
mail Settings] > [SMTP Server Settings].