Toyota 1 MZ–FE Manual page 77

1MZ–FE ENGINE – ENGINE MECHANICAL
(b) Secure the exhaust camshaft sub–gear to the main
gear with a service bolt.
Recommended service bolt:
Thread diameter 6 mm
Thread pitch 1.0 mm
Bolt length 16–20 mm
HINT: When removing the camshaft, make sure that
the torsional spring force of the sub–gear has been
eliminated by the above operation.
(c) Uniformly loosen and remove the 10 bearing cap
bolts, in several passes, in the sequence shown.
(d) Remove the 5 bearing caps and intake camshaft.
D. Remove exhaust camshaft of LH cylinder head
(a) Uniformly loosen and remove the 10 bearing cap
bolts, in several passes, in the sequence shown.
(b) Remove the 5 bearing caps, oil seal and exhaust cam–
shaft.
HINT:
Arrange the camshafts in the correct order.
Arrange the bearing caps in the correct order.
EG2–77