Toyota 1 MZ–FE Manual page 408

EG2–408
DIAGNOSTIC TROUBLE CODE CHART (Cont'd)
Detection Item
DTC No.
Random Misfire
P0300
Detected
Misfire Detected
P0301
– Cylinder 1
P0302
– Cylinder 2
P0303
– Cylinder 3
P0304
– Cylinder 4
P0305
– Cylinder 5
P0306
– Cylinder 6
Knock Sensor 1 Circuit
P0325
Malfunction
Knock Sensor 2 Circuit
P0330
Malfunction
Crankshaft Position
Sensor Circuit
P0335
Malfunction
Crankshaft Position
Sensor Circuit
P0336
Range/ Performance
Camshaft Position
Sensor Circuit
P0340
Malfunction
Exhaust Gas
Recirculation
P0401
Flow Insufficient
Detected
1MZ–FE ENGINE – DIAGNOSTIC TROUBLE CODE CHART
Diagnostic Trouble Code Detecting Condition
Misfiring of multiple cylinders is detected during the same 200 or
1,000 revolutions.
For each 200 revolutions of the engine, misfiring is detected which can cause
catalyst overheating.
(This causes MIL to blink.)
For each 1,000 revolutions of the engine, misfiring is detected which causes
emissions deterioration.
(2 trip detection logic)
No knock sensor 1 signal to ECM with engine speed 2,000 rpm or more.
No knock sensor 2 signal to ECM with engine speed 2,000 rpm or more.
No crankshaft position sensor signal to ECM during cranking.
(2 trip detection logic)
No crankshaft position sensor signal to ECM during engine running.
Deviation in crankshaft position sensor signal and camshaft position
sensor signal.
(2 trip detection logic)
No camshaft position sensor signal to ECM during cranking.
(2 trip detection logic)
No camshaft position sensor signal to ECM during engine running.
After the engine is warmed up and run at 80 km/h (50 mph) for 3 to 5
minutes, the EGR gas temperature sensor value does not exceed 40_C (104_F)
above the ambient air temperature,
(2 trip detection logic)