Oil Pump Assembly - Toyota 1 MZ–FE Manual

1MZ–FE ENGINE – LUBRICATION SYSTEM
(c) Apply MP grease to a new oil seal lip.
(d) Using SST and a hammer, tap in the oil seal until its
surface is flush with the oil pump body edge.
SST 09223 – 00010

OIL PUMP ASSEMBLY

(See Components for Disassembly and Assembly)
1. INSTALL DRIVE AND DRIVEN ROTORS
(a) Place the drive and driven rotors into pump body with
the marks facing the pump body cover side.
(b) Install the pump body cover with the 9 screws.
2. INSTALL RELIEF VALVE
(a) Insert the relief valve and spring into the pump body
hole.
(b) Install the plug with a new gasket.
Torque: 36.8 N–m (375 kgf–cm, 37 ft–lbf)
EG2–385