Toyota 1 MZ–FE Manual page 373

1MZ–FE ENGINE – LUBRICATION SYSTEM
(c) Apply clean engine oil to the gasket of a new oil filter.
(d) Lightly screw the oil filter into place, and tighten it
until the gasket contacts the seat.
(e) Using SST, tighten it an additional 3/4 turn.
SST 09228–07500
3. REFILL WITH ENGINE OIL
(a) Clean and install the oil drain plug with a new gasket.
Torque: 37 N–m (375 kgf–cm, 27 ft–lbf)
(b) Fill with fresh engine oil.
Oil grade:
API grade SG or SH, Energy – Conserving II or
ILSAC multigrade and recommended viscosity oil,
with SAE 5W–30 being the preferred engine oil.
Capacity:
Drain and refill
w/ Oil filter change
4.7 liters (5.0 US qts, 4.1 Imp. qts)
w/o Oil filter change
4.5 liters (4.8 US qts, 4.0 Imp. qts)
Dry fill
5.5 liters (5.8 US qts, 4.8 Imp. qts)
(c) Reinstall the oil filler cap.
4. START ENGINE AND CHECK FOR OIL LEAKS
5. RECHECK ENGINE OIL LEVEL
EG2–373