Timing Belt Inspection - Toyota 1 MZ–FE Manual

1MZ–FE ENGINE – ENGINE MECHANICAL
(b) Using SST, remove the crankshaft timing pulley.
SST 09213–60017 (09213–00020, 09213–00030,
09213–00050)
NOTICE: Do not scratch the sensor part of the crankshaft
timing pulley.

TIMING BELT INSPECTION

1. INSPECT TIMING BELT
NOTICE:
Do not bend, twist or turn the timing belt inside out.
Do not allow the timing belt to come into contact
with oil, water or steam.
Do not utilize timing belt tension when installing or
removing the mount bolt of the camshaft timing
pulley.
If there are any defects, as shown in the illustrations,
check the following points:
(a) Premature parting
Check for proper installation.
Check the timing cover gasket for damage and
proper installation.
(b) If the belt teeth are cracked or damaged, check to see
if either camshaft is locked.
(c) If there is noticeable wear or cracks on the belt face,
check to see if there are nicks on the side of the idler
pulley lock and water pump.
EG2–47