Toyota 1 MZ–FE Manual page 113

1MZ–FE ENGINE – ENGINE MECHANICAL
32. CONNECT ENGINE WIRE TO ENGINE RH SIDE
(a) Connect the following connectors:
(1) 3 injector connectors
(2) 3 ignition coil connectors
(3) Water temperature sender gauge connector
(4) Water temperature sensor connector
(5) RH oxygens sensor connector
(b) Connect the engine wire with the 5 nuts.
33. CONNECT ENGINE WIRE TO ENGINE REAR SIDE
(a) Connect the following connectors:
(1) LH oxygen sensor
(2) Engine coolant temperature sensor
(3) Camshaft position sensor
(b) Connect the 3 clamps.
(c) Connect the engine wire with the 2 nuts.
34. CONNECT ENGINE WIRE TO N0.3 TIMING BELT
COVER
Connect the engine wire with the 2 clamps.
EG2–113