Toyota 1 MZ–FE Manual page 262

EG2–262
1MZ–FE ENGINE – SFI SYSTEM
2. INSPECT MAF METER OPERATION
(a) Connect the MAF meter connector.
(b) Using a voltmeter, connect the positive (+) tester
probe to terminal VG, and negative (–) tester probe to
terminal E21.
(c) Blow air into the MAF meter, and check that the
voltage fluctuates.
If operation is not as specified, replace the MAF
meter.
(d) Disconnect the MAF meter connector.
MAF METER INSTALLATION
(See Components for Removal and Installation)
1. INSTALL MAF METER
(a) Insert the MAF meter end into the air cleaner case.
(b) Install the MAF meter with the 2 bolts.
Torque: 6.9 N–m (70 kgf–cm, 61 in.–Ibf)
(c) Connect the MAF meter connector.
2. INSTALL AIR CLEANER HOSE
(a) Install the air cleaner hose with the 2 hose clamps.
(b) Connect the PCV hose.
3. CONNECT NEGATIVE (–) TERMINAL CABLE
TO BATTERY