Toyota 1 MZ–FE Manual page 67

1MZ–FE ENGINE – ENGINE MECHANICAL
16. REMOVE INTAKE AIR CONTROL VALVE FROM AIR
INTAKE CHAMBER
(a) Disconnect the A/C air hose.
(b) Remove the 3 nuts and data link connector 1 clamp.
(c) Remove the intake air control valve by prying a screw–
driver between the intake air control valve and air
intake chamber.
(d) Remove the gasket.
17. REMOVE A/C IDLE–UP VSV FROM AIR INTAKE
CHAMBER
(a) Disconnect the air hose.
(b) Remove the 2 bolts and A/C idle–up VSV.
18. REMOVE THROTTLE BODY FROM AIR INTAKE
CHAMBER
(a) Disconnect the following vacuum hoes:
(1) Vacuum hose from P port of EGR vacuum modu–
lator
(2) Vacuum hose from R port of EGR vacuum modu–
lator
(b) Remove the 2 bolts, 2 nuts, throttle body and gasket.
19. REMOVE EGR VALVE AND VACUUM MODULATOR
FROM AIR INTAKE CHAMBER
Remove the 3 nuts, EGR valve, vacuum modulator and
gasket.
20. DISCONNECT ENGINE WIRE FROM ENGINE LH
SIDE
(a) Disconnect the following connectors:
(1) 3 injector connectors
(2) 3 ignition coil connectors
(b) Remove the 2 nuts, and disconnect the engine wire.
EG2–67