Toyota 1 MZ–FE Manual page 391

1MZ–FE ENGINE – LUBRICATION SYSTEM
14. INSTALL GENERATOR
Install the generator with the 2 bolts. Do not tighten
the bolts yet.
15. INSTALL NO.3 TIMING BELT COVER
(a) Check that the timing belt cover gaskets have no
cracks or peeling, etc.
If the gaskets do have cracks or peeling etc., replace
them using the following steps.
(1) Using a screwdriver and gasket scraper, remove
all the old gasket material.
(2) Thoroughly clean all components to remove all
the loose material.
(3) Remove the backing paper from a new gasket
and install the gasket evenly to the part of the
belt cover shaded black in the illustration.
NOTICE: When joining gaskets, do not leave a gap be–
tween them. Cut off any excess gasket.
(4) After installing the gasket, press down on it so
that the adhesive firmly sticks to the belt cover.
(b) Install new gaskets to the No.3 belt cover.
(c) Install the belt cover with the 6 bolts.
Torque: 8.5 N–m (85 kgf–cm. 74 in.–lbf)
16. CONNECT ENGINE WIRE
(a) Connect the generator connector.
(b) Connect the generator wire with the nut.
(c) Connect the engine wire with the 3 clamps.
EG2–391