Toyota 1 MZ–FE Manual page 180

EG2–180
1MZ–FE ENGINE – ENGINE MECHANICAL
(c) Hold the crankshaft pulley bolt with a wrench, and
install the 6 bolts evenly.
Torque: 41 N–m (420 kgf–cm, 30 ft–lbf)
HINT: First install the dark green colored bolt, then
install the other bolts.
(d) Install the flywheel housing under cover with the 2
bolts.
Torque: 18 N–m (185 kgf–cm, 13 ft–lbf)
4. INSTALL OIL DIPSTICK GUIDE AND DIPSTICK
FOR TRANSMISSION
(a) Install a new 0–ring to the dipstick guide.
(b) Apply soapy water to the 0 – ring.
(c) Connect the dipstick guide end to the dipstick tube of
the oil pan.
(d) Install the dipstick guide with the bolt.
(e) Install the dipstick.
5. CONNECT ENGINE WIRE
(a) Connect the following parts:
(1) O/D solenoid connector
(2) PNP switch speedometer
(3) Starter 50 terminal
(4) Starter B terminal
(5) Speed sensor connector
(b) Disconnect the 2 wire clamps from the transaxle.
(c) Install the 2 wire clamps to the transaxle.