Toyota 1 MZ–FE Manual page 55

1MZ–FE ENGINE – ENGINE MECHANICAL
16. INSTALL CRANKSHAFT PULLEY
(a) Align the pulley set key with the key groove of the
pulley, and slide the pulley.
(b) Using SST, install and torque the bolt.
SST 09213–54015, 09330–00021
Torque: 216 N–m (2,200 kgf–cm, 159 ft–lbf)
17. INSTALL NO.2 GENERATOR BRACKET
Install the bracket with the pivot bolt and nut. Do not
tighten the bolt yet.
Torque: 28 N–m (290 kgf–cm, 21 ft–lbf) for Nut
18. INSTALL NO.2 RH ENGINE MOUNTING BRACKET
AND ENGINE MOVING CONTROL ROD
Install the mounting bracket and control rod with the
3 bolts.
Torque: 63.7 N–m (650 kgf–cm, 47 ft–lbf)
19. INSTALL RH ENGINE MOUNTING STAY
Install the mounting stay with the 3 bolts.
Torque: 31.4 N–m (320 kgf–cm. 23 ft–lbf)
24. CONNECT GROUND STRAPS
Connect the 2 straps.
EG2–55