Toyota 1 MZ–FE Manual page 286

EG2–286
1MZ–FE ENGINE – FE ENGINE – SFI SYSTEM
C. Inspect VSV operation
(a) Check that the air flows from ports E to G.
(b) Apply battery voltage across the terminals.
(c) Check that the air flows from port E to the filter.
If operation is not as specified, replace the VSV.
6. REINSTALL EMISSION CONTROL VALVE SET
(See step 8 on page EG2–256)
7. REINSTALL VSV
(a) Install the VSV with the screw.
(b) Connect the 2 vacuum sensing hoses to the VSV.
8. REINSTALL V–BANK COVER
Using a 5 mm hexagon wrench, install the V–bank
cover with the 2 cap nuts.
HINT: For fixing the V–bank cover, push on the cover
until sense of "click" is felt.
9. RECONNECT NEGATIVE (–) TERMINAL CABLE
TO BATTERY