Toyota 1 MZ–FE Manual page 254

EG2–254
1MZ–FE ENGINE – SFI SYSTEM
2. CONNECT FUEL INLET AND RETURN HOSES
(a) Connect the fuel inlet hose to the fuel filter with the 2
new gaskets and union bolt.
Torque: 30 N–m (300 kgf–cm, 22 ft–lbf)
(b) Connect the fuel return hose to the No.1 fuel pipe.
HINT: Pass the fuel return hose under the heater
hoses.
3. INSTALL AIR ASSIST HOSES AND PIPE
(a) Connect the air assist hoses to the intake manifold.
(b) Install the air assist pipe to the bracket on the No.1
fuel pipe.
4. CONNECT INJECTOR CONNECTORS
5. INSTALL AIR INTAKE CHAMBER ASSEMBLY
(a) Using a 8 mm hexagon wrench, install a new gasket
and the air intake chamber assembly with the 2 bolts
and 2 nuts.
Torque: 43 N–m (440 kgf–cm, 32 ft–lbf)
(b) Connect the ground strap with the bolt.
(c) Install the bolt holding the No.1 engine hanger to the
air intake chamber.
Torque: 39 N–m (400 kgf–cm, 29 ft–lbf)
(d) Connect the PS pressure tube with the nut.