Toyota 1 MZ–FE Manual page 117

1MZ–FE ENGINE – ENGINE MECHANICAL
(j) Connect the RH oxygen sensor connector clamp to
the PS pressure tube.
(k) Connect the ground strap with the bolt.
(1) Connect the hydraulic pressure pipe to the air intake
chamber with the bolt.
(m) Connect the following hoses:
(1) Brake booster vacuum hose
(2) PCV hose
(3) Intake air control valve vacuum hose
(n) Connect the data link connector 1.
(o) Connect the 2 ground straps with the nut.
Torque: 14.5 N–m (145 kgf–cm, 10 ft–lbf)
41. INSTALL EMISSION CONTROL VALVE SET
(a) Install the emission control valve set with the 2 bolts.
Torque: 8 N–m (80 kgf–cm, 69 in.–lbf)
(b) Connect the following connectors:
(1) Intake air control connector
(2) Fuel pressure connector
(3) EGR VSV connector
EG2–117