Toyota 1 MZ–FE Manual page 54

EG2–54
1MZ–FE ENGINE – ENGINE MECHANICAL
(c) Install the belt cover with the 5 bolts.
Torque: 8.5 N–m (85 kgf–cm. 74 in.–lbf)
14. CONNECT ENGINE WIRE
(a) Connect the engine wire with the clamp.
(b) Install the bolt holding the engine wire to the No.3
timing belt cover.
15. INSTALL NO.1 TIMING BELT COVER
(a) Check that the timing belt cover gaskets have cracks
or peeling, etc.
If the gasket does have cracks or peeling, etc., replace
it using following steps, peeling, etc., replace them
using following steps.
(1) Using a screwdriver and gasket scraper, remove
all the old gasket material.
(2) Thoroughly clean all components to remove all
the loose material.
(3) Remove the backing paper from a new gasket
and install the gasket evenly to the part of the
belt cover shaded back in the illustration.
NOTICE: When joining 2 gaskets, do not leave a gap
between them. Cut off any excess gasket.
(4) After installing the gasket, press down on it so
that the adhesive firmly sticks to the belt cover.
(b) Install new gaskets to the No.1 belt cover.
(c) Install the belt cover with the 4 bolts.
Torque: 8.5 N–m (85 kgf–cm, 74 in.–lbf)