Toyota 1 MZ–FE Manual page 173

1MZ–FE ENGINE – ENGINE MECHANICAL
(b) Apply seal packing to the oil pump as shown in the
illustration.
Seal packing:
Part No. 08826–00080 or equivalent
Install a nozzle that has been cut to a 2–3 mm
(0.08–0.12 in.) opening.
HINT: Avoid applying an excessive amount to the
surface.
Parts must be assembled within 3 minutes of
application. Otherwise the material must be re–
moved and reapplied.
Immediately remove nozzle from the tube and
reinstall cap.
(c) Place a new O–ring in position on the cylinder block.
(d) Engage the spline teeth of the oil pump drive gear with
the large teeth of the crankshaft, and slide the oil
pump on the crankshaft.
(e) Install the oil pump with the 9 bolts.
Torque:
8 N–m (80 kgf–cm, 69 in.–lbf) for 10 mm head bolt
19.5 N–m (200 kgf–cm,14 ft–lbf) for 12 mm head bolt
EG2–173