Toyota 1 MZ–FE Manual page 388

EG2–388
1MZ–FE ENGINE – LUBRICATION SYSTEM
(c) Install the oil pan with the 17 bolts.
Torque:
8 N–m (80 kgf–cm, 69 in.–lbf) for 10 mm head bolt
19.5 N–m (200 kgf–cm. 14 ft–lbf) for 12 mm head bolt
4. INSTALL OIL STRAINER
Install a new gasket and the oil strainer with the bolt
and 2 nuts.
Torque: 8 N–m (80 kgf–cm, 69 in.–lbf)
5. INSTALL NO.2 OIL PAN
(a) Remove any old packing (FIPG) material and be care.
ful not to drop any oil on the contact surface of the
No. 1 and No.2 oil pans.
Using a razor blade and gasket scraper, remove
all the old packing (FIPG) material from the
gasket surfaces and sealing grooves.
Thoroughly clean all components to remove al
the loose material.
Using a non–residue solvent, clean both sealing surfaces.
NOTICE: Do not use a solvent which will affect the paint
ed surfaces.
(b) Apply seal packing to the No.2 oil pan as shown in the
illustration.
Seal packing:
Part No. 088218–00080 or equivalent
Install a nozzle that has been cut to a 4–5 mm
(0.16 – 0.20 in.) opening.
HINT: Avoid –applying an excessive amount to the
surface.
Parts must be assembled within 3 minutes an
application. Otherwise the material must be re–
moved and reapplied.
Immediately remove nozzle from the tube and
reinstall cap.