Polycom DMA 7000 Operation Manual page 94

DMA Operations Guide
86
Table 6-2 Add Conference Template dialog box (continued)
Field
RMX Recording
Record conference
Recording link
Audio only
Tandberg Codian
Floor and chair control
Layout control via
FECC/DTMF
Content channel video
Conference custom
layout
Description
The conference recording setting for this template:
• Disabled — Recording isn't available for
conferences using this template.
• Immediately — Recording starts automatically when
the conference starts.
• Upon Request — Recording can be initiated
manually by the chairperson or an operator.
Conference recording requires a Polycom RSS
recording system and an MCU that supports recording.
Select a specific recording link or the MCU's default.
The list contains the names of all recording links
available on the connected MCUs, with the number of
MCUs that have the link shown in parentheses.
Available only on RMX v7 MCUs.
Limits recording to the audio channel of the conference.
Specifies how much control conference participants may
have:
• Do not allow — Participants have no control.
• Floor only — A participant may "take the floor."
Everyone sees that participant's video full-screen.
• Floor and chair control — A participant may also
"take the chair." The chair can designate whose
video everyone sees full-screen. The chair can also
disconnect participants.
This setting works only in H.323 conferences and only if
H.243 Floor and Chair Control is enabled on the MCU.
All endpoints must support H.243 chair control.
Enables participants to change their individual layouts
using far end camera control or touchtones.
Enables the conference to support a second video
stream for content.
This setting works only if Content Status is enabled on
the MCU.
Opens the Select Layout dialog box, where you can
select the number and arrangement of video frames.
Once a layout is chosen, a small representation of it
appears here. See "Select Layout Dialog Box"
page 94.
Conference Templates
on
Polycom, Inc.