System Time - Polycom DMA 7000 Operation Manual

System Time

System Time
Polycom, Inc.
See also:
"System Time" on page 43
"License" on page 44
"Signaling Configuration"
"Logging Configuration"
"History Record Retention"
"CMA Integration"
"System Configuration Procedures"
The following table describes the fields on the System Time page. These
values are normally set in the USB Configuration Utility during system
installation and rarely need to be changed. See the Getting Started Guide.
Caution
Changing time settings requires a system restart and terminates all active
conferences.
You can't change the system's time settings while it's integrated with a Polycom
CMA system. The integration must first be terminated. See
page 49.
Table 4-2 Fields on the System Time page
Field
System time zone
Auto adjust for Daylight
Saving Time
Manually set system
time
NTP Servers
on page 45
on page 47
on page 48
on page 49
on page 51
Description
Time zone in which the system is located. We
recommend selecting the time zone of a specific
geographic location, not the GMT offset.
Leave this selected to avoid a number of potential
issues.
If you turn this off, the system converts the specific
geographic time zone selected into the corresponding
GMT offset time zone.
We don't recommend setting time and date manually.
Specify up to three time servers for maintaining system
time (we recommend three). Enter IP addresses or, if
DNS servers are specified, fully qualified domain
names.
System Configuration
"CMA Integration" on
43