Polycom DMA 7000 Operation Manual page 176

DMA Operations Guide
168
Verify that the oldest backup file listed is one you don't want to keep or
2
have already downloaded.
Only ten files are saved. Uploading a backup will delete the oldest file
(unless there are fewer than ten).
In the Actions list, click Upload.
3
Choose a backup file to upload and click Open.
4
The File Upload dialog box indicates when the upload is complete.
Click Close.
5
The system asks if you want to restore now from the backup file you just
uploaded.
If you don't want to restore (and restart the system) now, click Manually
6
Later. When you're ready to restore, use the procedure that follows this
one.
To restore now, make sure you meet the criteria in the first step of the
7
following procedure, and click Now. When asked to confirm, click Yes.
A dialog box informs you when all files have been restored.
Click OK.
8
The system logs you out and the server reboots (typically, this takes about
five minutes). After it comes back up, in a two-node system, the second
node syncs to it, thus being restored to the same state.
To restore from a backup file on the server
If this is a two-node system, make sure that both nodes are running and
1
clustered. Make sure that there are no calls on the system, and that all
MCUs are out of service. See
Go to Operations > Backup and Restore.
2
Select the backup file from which you want to restore.
3
In the Actions list, click Restore Selected.
4
When asked to confirm that you want to restore, click Yes.
5
A dialog box informs you when all files have been restored.
Click OK.
6
The system logs you out and the server reboots (typically, this takes about
five minutes). After it comes back up, in a two-node system, the second
node syncs to it, thus being restored to the same state.
"MCU Procedures" on page 64.
Backing Up and Restoring
Polycom, Inc.