Signaling Configuration - Polycom DMA 7000 Operation Manual

Signaling Configuration

Signaling Configuration
Polycom, Inc.
See also:
"Network" on page 41
"System Time" on page 43
"Signaling Configuration"
"Logging Configuration"
"History Record Retention"
"CMA Integration"
"System Configuration Procedures"
On the Signaling Configuration page, you can configure H.323 signaling
(gatekeeper registration) and SIP signaling.
The following table describes the fields on the Signaling Configuration page.
Table 4-4 Fields on the Signaling Configuration page
Field
H.323 and SIP Shared Settings
Dialing prefix
H.323 Settings
Enable H.323 signaling
H.323 signaling status
on page 45
on page 47
on page 48
on page 49
on page 51
Description
E.164 dial string prefix for calling the system. Required
if registering with a gatekeeper.
Must be unique among the gatekeeper's devices and
services. On Polycom gatekeepers, if the Simplified
Dialing service is enabled and registers with a prefix of 9
(the default), you can't use 90-99. The gatekeeper
recognizes the 9 as a known prefix and ignores the
second digit.
If specified, the prefix is used for SIP calls as well so
that the same number can be dialed from both H.323
and SIP endpoints.
Caution: Changing the dialing prefix terminates any
existing H.323 calls. When you click Update, the
system prompts you to confirm.
Enables the system to receive H.323 calls.
Caution: Disabling H.323 terminates any existing H.323
calls. When you click Update, the system prompts you
to confirm.
Status of signaling module. Ready to receive calls if
registered with a gatekeeper, Ready to receive IP-only
calls if not.
System Configuration
45